Micro-Liter OEM Syringe Pump Modules

Art.-Nr. 00068

The new “µl” Pump Module is a low cost, highly precise, single syringe infuse/withdraw pump capable of low to moderate back pressures. It is available in one version only and will hold one syringe of any make from 0.5 µl to 1 ml. The inside diameter of the syringe and desired flow rate are entered via the RS-232 serial port, and the internal microprocessor drives a precision stepper motor to produce accurate fluid flow. This unit is designed to operate inside an enclosure, cabinet, or on top of a bench. The board may be removed for “remote” operation.

  • RoHs compliant
  • Low cost syringe pump
  • Easy to incorporate legendary syringe pump technology into your equipment
  • Precisely dispenses micro-liter volumes
  • Smooth flow
  • Two modes of operation
    • Constant flow rate
    • Volume dispense

Two Modes of Operation - Constant Flow Rate and Volume Dispense
The “µl” Pump Module will operate continuously in RATE mode or accurately dispense a specific amount of fluid in VOLUME mode. When starting the pump, RATE mode will be the default mode. To operate in Volume mode, set a target volume and the pump will change modes to suit desired operation. This is the safest way to use the “µl” Pump Module. The pump will automatically stop when target volume is dispensed.

Smooth Flow
New micro-stepping pump profiles deliver very smooth and consistent flow.

Location Requirements for the Syringe Pump

  • A sturdy, level, clean and dry surface
  • Minimum of one inch (2.5 cm) clearance around the pump
  • Adequate power supply
  • Operating temperature 0° to 35°C (32° to 95°F)
  • Relative humidity 20% to 80%

Protecting Small, Fragile Syringes
The “µl” Pump Module will hold microliter size syringes down to 0.5µl size. These small syringes have fine wire plungers that may be damaged if allowed to bottom out. The “µl” Pump Module is equipped with adjustable limit switches on the bottom side of the mounting plate. Make sure to adjust the limit switches to prevent damage to small syringes.

of Syringes11
Accuracy UOM%%
Average Linear Force66
Average Linear Force UOMlb (maximum)lb (maximum)
CommunicationsRS-232 with simple command languageRS-232 with simple command language
ConnectorsRS-232 4 pin RJ-11 telephone jack; dual RS-232 ports
DC Power 4-pin Header (Friction lock)"
RS-232 4 pin RJ-11 telephone jack; dual RS-232 ports
DC Power 4-pin Header (Friction lock)
Depth English3.253.25
Depth English UOMinin
Depth Metric8.38.3
Depth Metric UOMcmcm
Drive ControlL/R Drive, 0.75A per phase, 1/4 steppingL/R Drive, 0.75A per phase, 1/4 stepping
Drive Lead Screw Pitch48 threads per inch (1/4-48)48 threads per inch (1/4-48)
Drive Ratio1:1 (Direct Drive)1:1 (Direct Drive)
Environmental Humidity20 to 80% RH non-condensing20 to 80% RH non-condensing
Environmental Operating Temperature Metric0 to +350 to +35
Environmental Operating Temperature Metric UOM°C (natural convection cooling)**Note: operating temperature may be extended with forced air cooling°C (natural convection cooling)**Note: operating temperature may be extended with forced air cooling
Environmental Storage Temperatue Metric+20 to +70+20 to +70
Environmental Storage Temperatue Metric UOM°C°C
Flow Rate Maximum0.8540.854
Flow Rate Maximum UOMml/min (with 1 ml syringe)ml/min (with 1 ml syringe)
Flow Rate Minimum0.00140.0014
Flow Rate Minimum UOMµl/hr with 0.5 µl syringeµl/hr with 0.5 µl syringe
Height English4.54.5
Height English UOMinin
Height Metric11.411.4
Height Metric UOMcmcm
Limit SwitchOne for each direction (end of travel)One for each direction (end of travel)
Motor0.9° step angle motor0.9° step angle motor
Mounting HolesMounting holes for (4) #8 screwsMounting holes for (4) #8 screws
Mounting Length English8.758.75
Mounting Length English UOMinin
Mounting Length Metric22.222.2
Mounting Length Metric UOMcmcm
Mounting Width English2.752.75
Mounting Width English UOMinin
Mounting Width Metric77
Mounting Width Metric UOMcmcm
Net Weight English1.851.85
Net Weight English UOMlbslbs
Net Weight Metric0.840.84
Net Weight Metric UOMkgkg
Pump FunctionInfuse/WithdrawInfuse/Withdraw
Pusher Travel Rate Maximum47.647.6
Pusher Travel Rate Maximum UOMmm/minmm/min
Pusher Travel Rate Minimum2.92.9
Pusher Travel Rate Minimum UOMµm/minµm/min
Step Rate Maximum416.7416.7
Step Rate Maximum UMOµsec/stepµsec/step
Step Rate Minimum6.86.8
Step Rate Minimum UOMsec/stepsec/step
Syringe Rack TypeHolds 1 syringe made from either glass or plasticHolds 1 syringe made from either glass or plastic
Syringe Size Maximum11
Syringe Size Maximum UOMmlml
Syringe Size Minimum0.50.5
Syringe Size Minimum UOMµlµl
TypeMicroprocessor single syringe, infusion/withdrawMicroprocessor single syringe, infusion/withdraw
Voltage Range(+)12VDC, 5%, 1A (12W) (User supplied)(+)12VDC, 5%, 1A (12W) (User supplied)
Width English9.259.25
Width English UOMinin
Width Metric23.523.5
Width Metric UOMcmcm
Auf den Merkzettel